Trouble

Raspbian :Wifi not working : wlan0: link is not ready

3 10352
Using : Banana PI with Raspbian latest

I am unable to get my ralink wifi USB adapter work on banana pi.
Same works on raspberry pi.

I logged into the serial connection to find the error.
I see that the adapter is detected but some driver error.
        wlan0: link is not ready

I have latest ra-link drivers (I have tried sudo apt-get install firmware-ralink)
If anyone has encountered this error and resolved please let me know

LOG :
bananapi@lemaker:~$ ehci_irq: port change detect
<6>usb 3-1: new high-speed USB device number 2 using sw-ehci
<6>usb 3-1: New USB device found, idVendor=148f, idProduct=5370
<6>usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
<6>usb 3-1: Product: 802.11 n WLAN
<6>usb 3-1: Manufacturer: Ralink
<6>usb 3-1: SerialNumber: 1.0
<6>usb 3-1: reset high-speed USB device number 2 using sw-ehci
<7>ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
<7>Registered led device: rt2800usb-phy0::radio
<7>Registered led device: rt2800usb-phy0::assoc
<7>Registered led device: rt2800usb-phy0::quality
<6>usbcore: registered new interface driver rt2800usb
rtusb init rt2870 --->
sw_usb_enable_hcd: usbc_num = 2
<6>usbcore: registered new interface driver rt2870
<6>ADDRCONF(NETDEV_UP): wlan0: link is not ready


somehow managed to get this working. Some trial and error adding removing the drivers

gekko67  
Edited by gekko67 at Thu Jan 1, 2015 09:43

If you use banana pro. open lx terminal and start The patched version (only for banana pro) "sudo modprobe ap6210"
My Problem is to start this application automatically. Is there somebody who can show me, where i have to do this?

Edited by balli1187 at Sat Jan 3, 2015 06:19

@gekko67:

You can load it automatically by adding "ap6210" in a single line to the file "/etc/modules"

Regards

You have to log in before you can reply Login | Sign Up

Points Rules