Discussion

wiring pi

13 7861
sebo  
Hy @all,
i read that the banana pi supports wiring pi since release 3.0, but i really have problems with this.
Does anyone else tested it, or got issues with this, or is that my fault.
Thanks for answers.
We only pre-installed modified wiringPi in Raspbian 3.0. What's is your problem?

sebo  
I´m trying to use 433 mhz Transmitter module with wiring pi + rc.switch module.
But it doesnt work ...

sebo  
any ideas ? does anyone get it work ?

433 mhz Transmitter module , I don't know this module. What bus did this module use? I2C or SPI? If SPI, it don't work.

I don't know about the hardware you've got, but wiring pi/rcswitch seems work for me (I've got distinct 433Rf receiver and transmitter, and use https://github.com/ninjablocks/433Utils as a starting point)
Does your code work with a raspberry ?

Reply 6# egalland

Hi egalland,could you post some images of using 433Rf on the forum?

sebo  
hy thx for reply, yes the code works under with raspberry pi

Reply 7# tony_zhang

Hello,
what kind of image would you like?
Here are an hardware shot and a screenshot of my webui.

BPI & Breadboard (with RF433 transmitter and receiver)

BPI & Breadboard (with RF433 transmitter and receiver)

Incoming RF433 signals

Incoming RF433 signals


I've got a question: are all the pins in the same "mode" by default? (I mean in/out, write 1/0 .. ).
I think pin 22/gpio 6 is out/0 on rpi and out/1 on bpi .. but I may be wrong

I´m also control with the FS1000A RF Send Unit and it works now for me...

try to do not 'sudo'ing the send-command

Intertechno Type B (YCR1000) switching now on with following command:

  1. root@lemaker:/var/www#  /opt/rc-switch/rcswitch-pi/send 2 1 1 1
  2. sending systemCodeType[2] systemCode[1] unitCode[1] command[1] ...
  3. defining transmit PIN[0] ... success
  4. computing system Code Type ...
  5. computing systemcode for Intertechno Type B house[1] unit[1] ... 1/A ... got systemCode
  6. 1 ... sent TriState signal: pSystemCode[000000000FFF]
  7. root@lemaker:/var/www#
Copy the Code


with sudo..

  1. root@lemaker:/var/www# sudo /opt/rc-switch/rcswitch-pi/send 2 1 1 1
  2. sending systemCodeType[2] systemCode[1] unitCode[1] command[1] ...
  3. defining transmit PIN[0] ... success
  4. computing system Code Type ...
  5. computing systemcode for Intertechno Type B house[1] unit[1] ... 1/A ... got systemCode
  6. 1 ... sent TriState signal: pSystemCode[000000000FFF]
  7. root@lemaker:/var/www#
Copy the Code



... i got the same output but, but there's happens nothing.


The Pins are working correctly with Raspbian V3.0

i compilled with the send-file from ths website..
http://www.gsurf.de/wp-content/uploads/2013/04/send.zip
there are specially works for codeable intertechno units

You have to log in before you can reply Login | Sign Up

Points Rules