Trouble

Bpi won't power sata hard drive

6 1401
mcfloyd  
Hello,
  I am having a problem where I have a 2.1 amp supply, readouts show max 406mA when idle, and hard drive shuts off the board when I plug in the power.

Here is the drive:
http://www.amazon.com/gp/product ... 1?ie=UTF8&psc=1
really good deal btw..

Datasheet says the drive pulls 900mA, which should be good running off a 2amp supply.
Any advice for troubleshooting?

Thanks,
-mcfloyd
Edited by actkk2000 at Tue Dec 30, 2014 23:29

I assume you start BPI with the disk already plugged in the SATA connectors (power + data), not that you plug it after because SATA port is not hot swap...
Also you need a compatible SATA cable like this:
http://forum.lemaker.org/forum.p ... 41&fromuid=1602
Or at least you have to connect SATA power this way:
http://forum.lemaker.org/forum.p ... 81&fromuid=1602

mcfloyd  
Edited by mcfloyd at Tue Dec 30, 2014 20:38

Ah, thank you.  The sata cable I got was wired the differently.  I'll fix it and try again.

edit: works!

Great!
Please add [solved] to title if you have the chance, thx!

Lol I thought u still had the problem

hodoors  
Note: The author has been banned or deleted.

BpI is not getting the power on the sata data hard drive and this is happening from a very long time. Hp support assistant has also done the configuration on the drive but the power issue was still there

You have to log in before you can reply Login | Sign Up

Points Rules