Bananian

Serial console help

5 1412
ttosi  
i just installed latest bananian image (15.01) which says it has serial console enabled by default. i can't seem to get a serial conection working . which pins on the bpro should i connect the Rx and Tx to my serial cable?
tkaiser  
Next to the Ethernet connector are 3 pins that are labeled with GND, RX and TX (zoom into the image if unclear: http://forum.lemaker.org/forum.p ... 2&fromuid=33332). Everything else is explained here: http://wiki.lemaker.org/Log_in_t ... the_TTL_serial_port

ttosi  
iam running on the banana pro which doesn't have any other pins except for the 40 pin headrer. i've tried physical pins 8(tx) and 10(rx) wth no luck. is the console serial on one of the other uarts for the BPro?

ttosi  
nvm that I just saw them -- must be blind.. am trying those now

tkaiser  
ttosi replied at Fri Jan 30, 2015 10:13
iam running on the banana pro which doesn't have any other pins except for the 40 pin headrer. i've  ...

What about the three pins in the lower right corner of this image:



On your 'Pro' these three pins are missing?

ttosi  
working now! thank you very much

You have to log in before you can reply Login | Sign Up

Points Rules