markwinger replied at Fri May 8, 2015 07:59
Is the resolution in the uEnv.txt file? Internet searches say 'boot' but I don't see it there. "fin ...
It's described in his FAQ:
screen resolution – change it + reboot:
mkimage -C none -A arm -T script -d /boot/boot.cmd /boot/boot.scr
And there you adjust disp.screen0_output_mode. I also made some tests using fbset ("apt-get install fbset") and added the following to /etc/fb.modes
and put aat the end of /etc/rc.local. But this leads to synchronisation problems and i don't get which timing parameters i would need for 1024x600 @ 60Hz. Note: I'm only talking about 1024x600 via HDMI Copy the Code
- mode "1024x600-75"
- # D: 65.003 MHz, H: 48.365 kHz, V: 75.807 Hz
- geometry 1024 600 1024 600 32
- timings 15384 160 24 29 3 136 6
- rgba 8/16,8/8,8/0,8/24