Edited by liab at Tue May 12, 2015 16:02 |
My bpi 1 is connected via hdmi2dvi to a 7" monitor and my bpi2 via hdmi to TV (hdmi). On both default is audio_codec and audio_hdmi and with both I cannot generate this message. You have the same configuration like my bpi 2?
I know a similar message on my bpi 2 (it goes not direct to The TV, there is a hdmi switch), if the switch is switched to another hdmi channel. Then CVBS works but there is a loop with the message: "HDMI cable is plugged out...". Then helps to unplug the hdmi cable.
Perhaps your image is damaged, or the bpi pro is a little bit other in that part of hardware.
I load up a new version
https://www.dropbox.com/s/edd5ko ... -120515.tar.gz?dl=0
The app Aud/WiFi now reads the current wlan driver status not from my own files, it reads it direct from libhardware_legacy.so