Interfacing

FYI: RPi Expansion boards on Lamobo R1

2 3181
tkaiser  
Edited by tkaiser at Thu May 7, 2015 03:29

Hi,

just wanted to let you know that Expansion boards for the original Raspberry Pi 26 GPIO connector do work directly and without bending connectors on the Lamobo R1 if their width doesn't exceed the width of the 26 pin GPIO connector. In the following example I connected a 1 Wire Pi. Fits exactly:







Most of the Expansion boards from AB Electronics for the original 26 pin GPIO header work without adjusting the height. In case the board is wider on the right side one must place something like this in between because then the USB connector becomes a problem:

T.S.  
Thanks for letting us known!

I know this w1 board very well as you may remember. Do you have some experience with sensors on longer distance (>10m)?

tkaiser  
Edited by tkaiser at Thu May 7, 2015 23:49
T.S. replied at Thu May 7, 2015 13:21
I know this w1 board very well as you may remember


I know, I followed your recommendation.

Until now no experiences at all with 1 Wire sensors. But here's a solution for longer cables that might work: http://forum.lemaker.org/forum.php?mod=redirect&goto=findpost&ptid=897&pid=33486

You have to log in before you can reply Login | Sign Up

Points Rules