Just a small addedum:|
Once connected to USB port, the Burning will identify if your device is in ADFU mode (in the line showing the number of device connected). If the device is not detected in ADFU mode, just follow this procedure, with the Guitar connected on your computer USB:
- press the ADFU switch on the side of the guitar
- while holding the ADFU switch, press the reset button on the Guitar board until the red LED switch off, then release the reset switch
- Once the burning tool detect a DFU device you can release the ADFU button.
Just had somme issue with random ADFU detection until I use this idiot-proof procedure.