Interfacing

Banana PI GPIO state during Boot

1 381
Hello.
I would like to know how can i set the state 0 from boot, because i need Pin 13from CON3 for output and it is a few seconds after power on at high level.

I think this must be done in the script.bin, but i don't know the parameters.

Hope someone can help.

Regards Peter.
xpeace  
Edited by xpeace at Mar 13, 2017 14:53

After one year ... http://forum.lemaker.org/thread-221-1-1.html

I managed to edit the Script.bin - however it did not change the behaviour.

Maybe within the Kernel there is also a GPIO initialization that needs to be edited.

You have to log in before you can reply Login | Sign Up

Points Rules