Discussion
The Schematic for BananaPi
15
24391
View: 24391|Reply: 15
|
[Discussion]
The Schematic for BananaPi
[Copy link]
|
|
Good!! |
|
|
|
|
|
|
|
thanks a lot ! ... I was looking for that information. |
|
|
|
|
|
|
|
I think there is a mistake on Banana one : On the SATA box, I think Vdd and Gnd of J5 connector have been switched on the schematic.
|
|
|
|
|
|
|
|
destroyedlolo replied at Tue Nov 18, 2014 05:12 
I think there is a mistake on Banana one : On the SATA box, I think Vdd and Gnd of J5 connector have ...
You are correct: For J5 the blue lettering "GND1" and "VDD5V" are obviously wrong.
I am not familiar with the pin numbering, so I can not say if the black numbers "1" and "2" also are wrong.
I had wired it without looking at the schematic just by checking which of the pins is connected to ground. The cable I bought had the black wire connected to ground and the red one to +VDD.
|
|
|
|
|
|
|
|
Edited by ericwilk at Sat Jan 10, 2015 01:33
-- removed to avoid confusion. My ghetto rigging the panel probably caused the issue in a very timely manner. |
|
|
|
|
|
|
|
ericwilk replied at Fri Jan 9, 2015 00:50 
NICE
Now if I could just find the format of the script.bin file and uEnv.txt that are on the boot p ...
Google on "uboot fex" and you will have the format for FEX/BIN files. |
|
|
|
|
|
|
|
destroyedlolo replied at Thu Jan 8, 2015 18:22 
Google on "uboot fex" and you will have the format for FEX/BIN files.
Oh, nice! So those repos actually have the source?
I'll have to check that out when I have a chance.
I have the screen working which was my goal, I only managed to damage a few components in the process (thank God for Duct Tape).
No really, I have crap taped together on the board itself, right now XD
I'm gonna revisit this once I get the touch screen digitizer. Those docs that were posted will help a lot. |
|
|
|
|
|
|
|
I have searched for dimensional drawings of the Banana Pi Pro board. I would like to design a case incorporating a small fan and an SSD mount |
|
|
|
|
|
|